GCC Printers Elite XL User Manual download pdf (Page 50)

Chapter 2

The Elite XL front panel

2-8 Chapter 2

6. Emulations

— Press the Enter key to access the four Emulations submenus. Three of these

submenus,Port Emulations, PostScript, and PCL, contain additional submenus. See note below.

Submenu Description Settings Notes

PS/PCL

Sensing

Determines if the printer will

automatically switch between

PostScript and PCL emulations;

or print only PostScript or only

PCL print jobs.

Auto switch, PostScript

only, and PCL only

To print PCL jobs, the factory

setting (PostScript only) must be

set to either Auto Switch or PCL

only. See Note below.

If you change the PS/PCL

Sensing submenu option, you must

switch the printer off and back on,

in order to for the new option

setting to be used.

Port

Emulations

(5 submenus)

The Port Emulations submenu

will only appear when PS/PCL

Sensing is set to Auto switch.

Parallel Determines if the Parallel port

will automatically switch between

PostScript and PCL emulations,

or accept only PostScript or only

PCL print jobs.

Auto switch, PostScript

only, and PCL only

See Note below.

RS422

Port

Determines whether the RS422

serial port will automatically

switch between PostScript and

PCL emulations, or accept only

PostScript or PCL print jobs.

Auto switch, PostScript

only, and PCL only

See note below.

LocalTalk

Port

Determines whether the

LocalTalk port will

automatically switch between

PostScript and PCL emulations,

or accept only PostScript or only

PCL print jobs.

Auto switch, PostScript

only, and PCL only

See note below.

EtherTalk

Port

Determines if the EtherTalk port

will automatically switch between

PostScript and PCL emulations,

or accept only PostScript or PCL

print jobs.

Auto switch, PostScript

only, and PCL only

This submenu will only appear

when the optional GCIO Ethernet

networking card is installed in the

printe. See Note below.

Note: The Elite XL’s auto-sensing and auto-switching features enable the printer to automatically sense and switch

between a PostScript print job and a PCL print job. If you print using both PostScript and PCL, set the PS/PCL Sensing

submenu to Auto switch. If PS/PCL Sensing is set to Auto switch, you can then set each interface port to either Auto

switch, PostScript only, or PCL only. Setting each interface port independently enables the printer to better distinguish

among PostScript and PCL print jobs. When PostScript and PCL are simultaneously active, available memory is

significantly less than when PS/PCL Sensing is set to either PostScript only or PCL only. If you require PostScript and

PCL to be simultaneously active and experience memory failures, we recommend that you increase the amount of RAM

installed in the printer.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 198 199

Comments to this Manuals

No comments

GCC Printers Elite XL User Manual Page 50

Comments to this Manuals