GCC Printers Elite XL User Manual download pdf (Page 178)

Upgrading the printer’s memory C-5

9. Remove SIMMs (if applicable).

If your printer has SIMMS in both connectors, and you are only replacing one

of them, remove the SIMM from the second connector (see previous illustra-

tion).

a. Place your index fingers under the back edge of the SIMM.

b. With your thumbs, slowly push the two retaining clips outward until

the clips clear the top surface of the SIMM; the SIMM will come free

and flip upwards.

c. Grasping the SIMM between your thumbs and index fingers,

pull the SIMM out towards you.

10. Insert the SIMM(s).

a. Position the SIMM(s) so that the notched corner of the SIMM is facing

towards the back and down into the printer.

b. Slide the SIMM straight down into the connector.

c. Rotate the SIMM downward, towards you until it “clicks” into place as

the retaining clips slip over the top of the SIMM.

Installing SIMMs into the Elite XL

Note: The SIMMs

pictured in the

illustration show

memory chips on

both sides of the

SIMM; the SIMM(s)

you are installing

may have memory

chips on only one

side.

Notch

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 198 199

No comments

GCC Printers Elite XL User Manual Page 178