GCC Printers Elite 12ppm User Manual download pdf (Page 12)

1-5

Different applications treat these changes in different ways.

GCC recommends that you make changes in the application’s Page Setup or Print dialog

boxes. If you find that you are making the same changes for every print job, use the Printer

Setup dialog boxes or the Elite 12ppm control panel menus to make these settings the

default.

You’ll find instructions on changing the settings through the control panel menus (or

GCC’s WebAdmin tool) elsewhere in the manual. The instructions for changing the set-

tings in the Printer Setup dialog boxes are in the sections on each type of computer or

operating system.

Page Setup and Print dialog boxes vary from application to application. You’ll find details

in your application’s manuals.

Setting up the Elite 12ppm

Choosing a location for the printer

Place the printer on a flat level surface in a well ventilated area away from direct sunlight

and areas where the air temperature and humidity can vary. Do not obstruct the fan vent

on the right side of the printer, and make sure that the fan vent does not blow air directly

onto someone’s face.

Use the diagram below to determine where to put your printer.

8 inches (200mm)

minimum overhead

clearance.

7.2 inches

(180mm)

1 inch

(25mm)

12.4 inches

(310mm)

without Duplex

10.8 inches

(270mm)

21.8 inches

(545mm)

with Duplex

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 192 193

No comments

GCC Printers Elite 12ppm User Manual Page 12